SWB 88 Tub Front Alloy Support Section

Hi

Can anyone advise on part number or stockist of the transverse alloy section which supports front end of tub floor on 88 inch Series 111 Lightweight, appears to act as anode to outriggers & disintegrate where bolted together ie in front of rear wheels.

This is alloy section just under/behind bulkhead behind driver seat above chassis crossmember no5. This close to full width birmabright upside down channel section carries front of tub floor and sits on outriggers. shaped a bit like _|¬

|
Rear |___tubfloor__ _-,seatbox
|

I am not confusing this part with the 3 MUC8949 transverse steel crossmember support rails or the 3 longitudinal under floor top hat rails or even the rear of tub angle mount 330271/MTC1039.

This is the 1 alloy member at front of floor at bottom/under seatback bulkhead.

Thanks

Mingdiesel

i thought it was part of tub not available seperately

Hi

On my S111 Lwt its like part of the bottom of the bulkhead.
Can be removed if I drill out rivets, not much use in it's current oxidised condition & will break up if I play with it.

Can't remember what it's like on a civvy S111 88.
Cannot see it in civvy drawings/parts diagrams.
Maybe the rear tub floor is just supported on the back of the bulkhead?

rgds

Peter