Sump, Cracked slightly

Afternoon, just noticed theres i tiny Dot type crack in my sump so im going to have it temporarly repaird.

obviosuly ill have to replace the gasket/seal. iv looked on ebay but there isnt any just like a silicone type stuff. is that all i need or is there a proper gasket?

cheers

Hi Matey, found this on the net.

Hope it helps.

The 300Tdi engines should not have a gasket - they have always used RTV type sealant. If a gasket is fitted that is probably why its leaking - the design of the mating face on the sump pan is not flat as it is not intended for a gasket. Take it off and clean up both side thoroughly and use sealant to refit. Also check that the sump itself is not distorted as it is only a tin can and sometimes if it has been removed with too much force (and was well stuck on with sealant) then it may be bent along where it seals, which doesn't help! A small hammer and a bit of patience will usually sort it out.


Stu

I think the 300Tdi engines do not use a gasket - they have always used RTV type sealant. the design of the mating face on the sump pan is not flat as it is not intended for a gasket.

snap

:tea::tea:

lol

well done cheers lads ill get a tube of that stuff orderd and get it off at the weekend.