bonnybrook
Active Member
- Posts
- 424
L322 Stuck suspension strut bolt.
- Thread starter bonnybrook
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 33,867
- Location
- North Shropshire
Is the weight supported? Put the top bolt back in place, it might help line things up
Henry_b
Think outside, no box required.
- Posts
- 15,509
- Location
- somewhere else
Put a JACK under the hub and lift it Slightly, if the weight of the hub is sitting on that bolt it'll bind..
Datatek
Well-Known Member
- Posts
- 45,015
- Location
- Near Poitiers SW France
A "just" ?
Henry_b
Think outside, no box required.
- Posts
- 15,509
- Location
- somewhere else
Auto correct..
- Posts
- 33,867
- Location
- North Shropshire
You don't want one of those anywhere near a landy!
bonnybrook
Active Member
- Posts
- 424
Only weight really is the strut. Had top bolt back in. Whole thing will pivot back and forth on that bolt. It’s just won’t move, heat, pen the lot. Been smacking the a large hammer. Can only assume it must be bent or seized solid it will not turn.
- Posts
- 33,867
- Location
- North Shropshire
Looks like it's out part way? Put some oil on it and shove it back in
Datatek
Well-Known Member
- Posts
- 45,015
- Location
- Near Poitiers SW France
Rusted in most likely.
bonnybrook
Active Member
- Posts
- 424
That’s just the thread on the nut side. Bolt on other side not moved a mm and won’t turn. There is no thread other side but it’s slightly wider . Never known out like it. Access poor other side due to brake hoses etc.
- Posts
- 33,867
- Location
- North Shropshire
Time for the hot spanner?
brianp38dse
Well-Known Member
- Posts
- 20,093
- Location
- heathrow
Needs a dugger dugger gun
bonnybrook
Active Member
- Posts
- 424
ukadamwest
Well-Known Member
- Posts
- 2,990
- Location
- Surrey
1600mm breaker bar !
brianp38dse
Well-Known Member
- Posts
- 20,093
- Location
- heathrow
bonnybrook
Active Member
- Posts
- 424
I did get a tiny turn on the bar earlier.
it’s soaking now and it will have a liberal amount of heat in the morning.
bloody half shafts come out now
holidaychicken
Well-Known Member
- Posts
- 4,014
- Location
- Kent
I have a 600 mm breaker bar for such jobs, if it’s anything like the Inner rear track control arm bolt I had to cut the bolt off either side . It had become one with the inside of the arm. messrs oxy and acetylene as above
bonnybrook
Active Member
- Posts
- 424
It’s had the bar. It’s quite awkward to get at the bottom bolt with the caliper in the way. That was off in Feb so at least i know that shifted easily in comparison. struts been on since 08 so I guess it could be rusted as one.
why is it always the passenger side front that goes. Had same on my last one.
holidaychicken
Well-Known Member
- Posts
- 4,014
- Location
- Kent
It’s the side that drives through all the puddles at the edge of the road
brianp38dse
Well-Known Member
- Posts
- 20,093
- Location
- heathrow
Not to mention going over all drain cover dips.
Similar threads
Evoque
Suspension
