Stuck in the mud in my TD5

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
julia,
here is the answer to centre diff locks and hence why no visit to the dealers is required.

http://www.landyzone.co.uk/lz/f8/td5-diff-lock-they-all-manual-select-34036.html

basically if you have traction control and hill decent you aint got diff lock on our age group of td5. a quick check would also be, to see if you can push the little stick over to the left. dont force it. it will be obvious if there is a gate there for it to go into.

tip for the muddy stuff is to stop just short with all four wheels still on terafirma.
select low range, little stick forward, and first gear. the engine will rev higher than normal so selecting second, if needed, will come sooner than normal.
the trick is to be gentle on the accelerator and keep moving at all times, no matter how slow, until you get to where you want to stop.

have a practice on a quite road/ carpark, but keep it slow and dont forget to select high range again before setting off home.


If all 4 tyres are slipping, is it possible that the TC can remove all power to all 4 wheels - effectivey leaving you with no drive at all ? Excuse my ignorance
 
Thanks Mat - that article was very interesting. I now know my car was made in solihul and is a TD5 EGR non-cat.

Yes, have already tried very gently pushing the little knob to the left and it didn't budge, so I assume I ain't got diff lock. Like one of the people posting in that other thread, I too heard a horrid grinding kind of noise when the TC was lit on the dashboard.

I am going to LR tomorrow, to pick up a new jack as they sold me the car without one grrrrrrr! and I will have a quick chat with someone in there, but I ain't paying them £47 to tell me i f*cked up!

Thanks to all for your replies - I have learnt a lot!
 
julia,

the horrid grinding noise you heard is normal.
as soon as the computer senses that a wheel is loosing traction it removes the drive to it or applies the brake to it to stop it from spinning. not sure which way it is done on ours.
this is done very quickly because it also wants to get the power back to that wheel as soon as possible.

therefore the noise you heard is normal, and it is the mechanics removing and reapplying the drive back to the wheel, very quickly hence it sounds like grinding. in theory it is like switching a light on and off very quickly.

moose1,

yes you are correct.
i have been in a situation with a very heavy weight (44t) on the back of a range rover and sat there going no where.
an extreme example but yes it can happen given a set number of factors.
 
julia,

the horrid grinding noise you heard is normal.
as soon as the computer senses that a wheel is loosing traction it removes the drive to it or applies the brake to it to stop it from spinning. not sure which way it is done on ours.
this is done very quickly because it also wants to get the power back to that wheel as soon as possible.

therefore the noise you heard is normal, and it is the mechanics removing and reapplying the drive back to the wheel, very quickly hence it sounds like grinding. in theory it is like switching a light on and off very quickly.

moose1,

yes you are correct.
i have been in a situation with a very heavy weight (44t) on the back of a range rover and sat there going no where.
an extreme example but yes it can happen given a set number of factors.

Thanks for the reply
 
Back
Top