- Posts
- 58,170
- Location
- Preston Lancs.
Correct, dash switch is momentary. This pulls relay 6 to power actuator and open latch. Relay 6 should then drop out and cut power to actuator.
P38A Sticky flap and broken rod
- Thread starter stuu
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Correct, dash switch is momentary. This pulls relay 6 to power actuator and open latch. Relay 6 should then drop out and cut power to actuator.
Grrrrrr
Technician, Bodgit & Scarper Ltd
- Posts
- 19,862
- Location
- Buckinghamshire, UK. ('95 DT)
Any capacitors on the circuit anywhere? Might be one to take voltage spikes out that has cooked? Or maybe tie a resistor in parallel to drop the current?
Grrrrrr
Technician, Bodgit & Scarper Ltd
- Posts
- 19,862
- Location
- Buckinghamshire, UK. ('95 DT)
Maybe replace relay in case it is a bit sticky?
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
Morning Tony.
- Posts
- 58,170
- Location
- Preston Lancs.
Relay is in BECM.
- Posts
- 58,170
- Location
- Preston Lancs.
Morning Alan, things getting better for you i hope.
Grrrrrr
Technician, Bodgit & Scarper Ltd
- Posts
- 19,862
- Location
- Buckinghamshire, UK. ('95 DT)
Real one or transistor type?
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
- Posts
- 58,170
- Location
- Preston Lancs.
Yes mate,thanks. Bit sore as nursery told me to keep my leg up all night.
Bloody hell bet nursey is sore as well.
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
stuu
Well-Known Member
- Posts
- 1,979
- Location
- Aberdeenshire
You hear it click on and off.
Button click voltage click no voltage
If you hold the button it dose the same which is correct.
No voltage at the actuator unless the buttons pressed.
Left a light hooked in the line all last night and so far all day today
Nothing at all so it's only getting power when it buttons pressed.
Button click voltage click no voltage
If you hold the button it dose the same which is correct.
No voltage at the actuator unless the buttons pressed.
Left a light hooked in the line all last night and so far all day today
Nothing at all so it's only getting power when it buttons pressed.
- Posts
- 58,170
- Location
- Preston Lancs.
If you get power to the plug on the actuator each time you press the button then it can only be faulty actuator or it is badly grounded.
stuu
Well-Known Member
- Posts
- 1,979
- Location
- Aberdeenshire
Hopefully a bad earth then lol
