- Posts
- 2,427
- Location
- Isle Sheppy
1999 4.6 Thor none starter won’t turn over its in park pushed the inhibit button new starter and solenoid new battery and re synced becm help at wits end now oh all fuses and relays good cheers for any help
P38A Starting issue
- Thread starter pete12345
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 33,940
- Location
- North Shropshire
Does it say P on the dash? Have you tried neutral?
- Posts
- 2,427
- Location
- Isle Sheppy
Yer it said p on dash ****ing with rain again now so will check all again in a bit I’ve got all the dash out and a new binical so will plug it all back in later I had the check engine light on then it wasn’t on but not sure I’ve it’s relevant on the petrol model
- Posts
- 12,660
- Location
- Sud ouest France !
Put it all back together and start again @pete12345.. 
- Posts
- 2,427
- Location
- Isle Sheppy
Yer trying mark
Henry_b
Think outside, no box required.
- Posts
- 15,509
- Location
- somewhere else
The push-connect small wire at the spade connector can corrode and cause issues Next check will the starter with a + wire to bypass the solenoid, if it turns then it's not the main earth (probably) or starter itself (probably) - likely then to be either the little wire that connects solenoid to starter.
Last edited:
- Posts
- 2,427
- Location
- Isle Sheppy
I’ve put a new starter and solenoid on it s that wire that connects the two should be ok I will try and workout the direct wire from the battery I’m guessing to the starter and make sure it turns over
- Posts
- 2,427
- Location
- Isle Sheppy
Checked dash no lights at all on it only light is key in ignition lite up and bleeping noises for door open and can here brake pump noise
- Posts
- 19,309
- Location
- Buckinghamshire, UK. ('95 DT)
- Posts
- 2,427
- Location
- Isle Sheppy
It worked when I jumped the relay but that’s what blew the starter relay and then no power to the solenoid will test the wiring to starter but it must be something to The ignition now as no lights on binical
- Posts
- 2,427
- Location
- Isle Sheppy
I’ve got a tester for wiring I’ve just checked the relay all good power to solenoid and power to main bolt but no green light to starter but I think that gets power when the key is turned
- Posts
- 2,427
- Location
- Isle Sheppy
Fink I be calling that auto Electrian again any ideas what colour wires go to the dash binical mabey damage to one of them
- Posts
- 2,427
- Location
- Isle Sheppy
brianp38dse
Well-Known Member
- Posts
- 20,094
- Location
- heathrow
Have you checked the fuses on the becm, its got to be some thing simple like a fuse.
- Posts
- 33,940
- Location
- North Shropshire
Mine did this last time i had the dash out, can only put it down to a dodgy connection behind the dash. Jiggled the plug and it's been perfect ever since
- Posts
- 2,427
- Location
- Isle Sheppy
Will check fuses when come back from shopping and post bloody enemy wants go out
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
I'm jumping in without reading the full thread,I take it you have power out from the ignition switch.Yours if you need it Pete.p m me
Attachments
- Posts
- 2,427
- Location
- Isle Sheppy
Yer think that’s ok Alan it’s lighting up around the key slot
- Posts
- 2,427
- Location
- Isle Sheppy
When you say fuses on becm Brian you mean seat box
brianp38dse
Well-Known Member
- Posts
- 20,094
- Location
- heathrow
Yes the seat box ones , often over looked
Similar threads
