90man
New Member
- Posts
- 239
- Location
- Peterborough
What would a starter motor cost to install on a 300tdi 90 new not rewind.
Starter Motor on 300tdi 90 price
- Thread starter 90man
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
andyb66
Well-Known Member
- Posts
- 1,795
- Location
- Middle of Salisbury Plain, Wiltshire
An exchange starter will be able £90 after the old unit surcharge is refunded.
Fitting isn't tricky. Just be careful removing the wires and wrap them in tape to insulate them while removeing and replaceing starter. That way you don't have to disconnect the battery and loose radio codes etc.
Fitting isn't tricky. Just be careful removing the wires and wrap them in tape to insulate them while removeing and replaceing starter. That way you don't have to disconnect the battery and loose radio codes etc.
90man
New Member
- Posts
- 239
- Location
- Peterborough
I have been offered 3 types of Starter to be supplied and installed.
Bosch at £230, Chinese £170, and rewind at £150, but the starter is
still going but lazy, and hiccups 1 in 3 starts, if i don't change till it
gives up completely, can i do any damage.
BTW its the original starter on the Landy
Bosch at £230, Chinese £170, and rewind at £150, but the starter is
still going but lazy, and hiccups 1 in 3 starts, if i don't change till it
gives up completely, can i do any damage.
BTW its the original starter on the Landy
andyb66
Well-Known Member
- Posts
- 1,795
- Location
- Middle of Salisbury Plain, Wiltshire
On Paddock Spares - Land Rover, Range Rover Parts & Accessories - Discovery, Defender and Freelander
Starter motor - NEW - 300TDI - DEFENDER p/n ERR5009N for £80.84 plus VAT.
If money is a problem then I would remove and test it. You may find that you have a high resistance connection somewhere due to corrosion. It may just need a new solenoid fitting.
Starter motor - NEW - 300TDI - DEFENDER p/n ERR5009N for £80.84 plus VAT.
If money is a problem then I would remove and test it. You may find that you have a high resistance connection somewhere due to corrosion. It may just need a new solenoid fitting.
90man
New Member
- Posts
- 239
- Location
- Peterborough
I've been offered a new VALEO starter motor at £170 fitted, so I am going to wait till this one packs up all together then replace with the VALEO.
Thanks for your help
Thanks for your help
motiztab
Member
- Posts
- 78
Do you off road? Because they fill up with water and mud.
Changed mine last year on the 200Tdi done it again this year. Each time it was the solenoid, just clean that but i did take the whole starter apart and clean out the muck from around the wires, gentle with the windings but can all be done and saves pounds!!
Now i have a spare just going to do the same to that then kept ready.
Also check your earth.
Changed mine last year on the 200Tdi done it again this year. Each time it was the solenoid, just clean that but i did take the whole starter apart and clean out the muck from around the wires, gentle with the windings but can all be done and saves pounds!!
Now i have a spare just going to do the same to that then kept ready.Also check your earth.
90man
New Member
- Posts
- 239
- Location
- Peterborough
No don't go off road just a poser
90man
New Member
- Posts
- 239
- Location
- Peterborough
No I am responsible for all the crap on the landy I was the second owner after a lady owner who had it from new no off roading
