Sorry gents... It's EAS again!

52 classic said:

White connectors cleaned thoroughly and the relay changed back to OE............. Glitch is cured we no longer have the theatrical curtsey before every mission. No noticeable height loss overnight either, so it looks like the job is done and a victory for LZ yet again! Added bonus was our government's 6 month MOT extension. Mine was due next week.

Click to expand...

Grrrrrr said:

I think that only starts in April. Mine's the same!

Click to expand...

brianp38dse said:

Thats a bugger as my van runs out tomorrow but needs a wheel bearing done, but i now have no way of getting it anywhere as i am not supposed to leave the house

Click to expand...

brianp38dse said:

Thats a bugger as my van runs out tomorrow but needs a wheel bearing done, but i now have no way of getting it anywhere as i am not supposed to leave the house

Click to expand...

Grrrrrr said:

Are the garages still open? Could Dopey drive it down there for you? Must be a piece of cake compared to an arctic.

Or were you planning on doing the bearing yourself? How about #1 son?

Click to expand...

brianp38dse said:

The bearing and hub need a very big press to get then out, i was going to take the hub off and run it down to a garage that did my mates one, but as i cant use the van it can all wait till this lot sorts its self out.

Click to expand...

wammers said:

My 20 ton press does bearings easily.

Click to expand...

brianp38dse said:

When they did my mates one (same van) they took it up to 30 ton used heat and hammers then turned gauge off and kept pumping till it went with an all mighty bang evidently they are notoriously bad and most replace hole hub assembly

Click to expand...

wammers said:

Removing the circlip helps.

Click to expand...

brianp38dse said:

It is a big circlip the bearing is 84mm x 48

Click to expand...