Soon to do my clutch.

mick 1986 · Mar 15, 2011

I'm replacing the clutch in the next few weeks or so, the biting point is getting ridiculous now.
I'm after some pointers from people who have done this on a TD4, mine is a 53. What el e did you replace while you were on? Mater/slave cylinder? DMF? Anything elce that may be changed at the same time worth wile doing?

fyne1 · Mar 15, 2011

Doing slave is a must as it is also th release bearing.

mick 1986 · Mar 16, 2011

So the list so far, clutch, master and slave cylinder, and the release bearing.
What about the DMF? Does it NEED replacing when the clutch is done?

joe27979 · Mar 16, 2011

Hi Mick-have u looked into bleeding it first? my biting point was non existent..bled through and now it's an inch off the mat! Happy days!

mick 1986 · Mar 17, 2011

Not yet mate. I suppose I should I go down that route first, it may save me some money!
How long did it take you to bleed yours? How much fluid did you use?

joe27979 · Mar 17, 2011

I put a tutorial on here not long ago. took about an hour to do and used approx 0.5litre of fluid. might be worth eyeballing the piston on your master cylinder behind clutch pedal for signs of a leaking seal.

mick 1986 · Mar 17, 2011

Ok mate. I will go have a search for your how2. Thanks for the advice, if I get stuck I will give you a shout.

joe27979 · Mar 18, 2011

http://www.landyzone.co.uk/lz/f9/td4-clutch-bleed-tutorial-137699.html

Soon to do my clutch.

mick 1986

Well-Known Member

fyne1

Active Member

mick 1986

Well-Known Member

joe27979

Well-Known Member

mick 1986

Well-Known Member

joe27979

Well-Known Member

mick 1986

Well-Known Member

joe27979

Well-Known Member

Similar threads