Some pic's of my newly installed engine

cornish rattler · Jun 23, 2016

Hi guys
I just thought i would post a few pic's of my newly installed disco 200tdi engine into my 90

flat · Jun 23, 2016

Looks great. Not sure why you didn't swap the defender spec items over though so that it looked factory?

Nice and neat though

zeaphod · Jun 23, 2016

Looks good, hoping to do this later in the year. Did the power steering pump have a double pulley as standard? How did you plumb the power steering in the end - I remember you asking about it.

Tim4x4 · Jun 23, 2016

Nice work CR I bet it will not stay that clean for long

cornish rattler · Jun 24, 2016

flat said:
Looks great. Not sure why you didn't swap the defender spec items over though so that it looked factory?

Nice and neat though

Thank', I just prefer the Disco look

cornish rattler · Jun 24, 2016

zeaphod said:
Looks good, hoping to do this later in the year. Did the power steering pump have a double pulley as standard? How did you plumb the power steering in the end - I remember you asking about it.

Cheer's yeah i will dig the part number out for you over the weekend but there are a few different pipes with different pump ends on and yes it does have the double pulley as std

cornish rattler · Jun 24, 2016

Tim4x4 said:
Nice work CR I bet it will not stay that clean for long

Yeah i know, not much i can do about that

cornish rattler · Jun 24, 2016

zeaphod said:
Looks good, hoping to do this later in the year. Did the power steering pump have a double pulley as standard? How did you plumb the power steering in the end - I remember you asking about it.

Here it is thought i would get it now NTC5494 but as i said there are a few different pipes, if you do use this pipe although it fits the box and pump ok its too short to fit the brackets on the front Xmember its about 2-3" short my plan it to get some threaded rod or bolts and make a bracket to come off the threaded clamp bolt holes probably a piece of light grade angle iron then i can cable tie it along with the winch cables to the new bracket.

zeaphod · Jun 24, 2016

Thanks, just what I needed to know

Some pic's of my newly installed engine

cornish rattler

Well-Known Member

Attachments

flat

Well-Known Member

zeaphod

Well-Known Member

Tim4x4

Well-Known Member

cornish rattler

Well-Known Member

cornish rattler

Well-Known Member

cornish rattler

Well-Known Member

cornish rattler

Well-Known Member

zeaphod

Well-Known Member

Similar threads