Snorkel arrived today
- Thread starter landowner
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Thanks, it's been stuck in the garage two years since that picture and is more sandy coloured now.
Might paint it back that colour and get the shovel and pick back on the wings
Thanks, it's been stuck in the garage two years since that picture and is more sandy coloured now.
Might paint it back that colour and get the shovel and pick back on the wings
Do it!
Its next on the list after I've sorted my 2.5n/a, only a rear axle change to do and sort the wiring out, should be good for a while then (except for the rear crank oil seal
)Looking forward to it
ratty
I'm not special I'm limited edition
- Posts
- 34,277
Watch out when you drill the windscreen pillar holes. Some of the snorkel destructions get you to drill one of the holes in the wrong place. Ya may want to do some research on it.
Thanks mate, will be careful when I come to fit it.
Got to figure out how to connect to my filter yet, might have to weld a short piece of tube to the inside of the bit that bolts on the wing to fit rubber pipe to, not looked at it seriously yet
THEengineer
whatever
- Posts
- 4,978
- Location
- near big mountains and lots of mud
Thanks mate, will be careful when I come to fit it.
Got to figure out how to connect to my filter yet, might have to weld a short piece of tube to the inside of the bit that bolts on the wing to fit rubber pipe to, not looked at it seriously yet
is yours a 300tdi? i have the same snorkel so could take pics
