shark teeth for tilt

hoping to get the top off my s3 and stick a tilt on, the windscreen doesn't have the sharks teeth to grip the front of the tilt that my s1 has.

do i need to buy a new screen with them on or are they an add on panel.

have looked at pix of s3's with tilts on and they seem to have them


could anyone advise please

it has a panel that bolts onto top of screen that has several points that rope securing tilt pulls under

Add on panel ...either riveted OR screwed onto the screen top .

All Wheel Trim Ltd. Land Rover frames

Might give you an idea of what you are looking for

thx, i can see the panel needed in one of those kits, so i shall give them a buzz and see if they sell one separately as i have hood and frame already

well i hope i do, will find out when i try and fit it

have you got the panels around the doors

i think exmoor trim sells them as seperate bits

hopefully have the door bits, i was just going to try the tilt and frame from my s1 first to see if i could get away without having to lay out a load of cash.

i have hard and soft tops for the s1 but the s3 only hard, but will probably be using the s3 more this year and the amount of condensation in it is a major pita which should be a lot less with a tilt

richbatch said:

i think exmoor trim sells them as seperate bits

Click to expand...

Yes - recently bought one via Paddocks.

tried paddocks, they didn't have any, all wheel trim wanted £65 for one plus £15 shipping which i thought was a tad excessive, so i will try some others or just keep my eyes on the bay see if one crops up.

It might be worth throwing a tape measure across the screens.
I think the series 1 is slightly narrower than the series 3, but don't take my word for it, There will be somebody on here who knows for definite.

i think you are right about the s1, it does seem slightly narrower than my s3 just going off how much of my non landrover sticks out when they are parked end on.