Series Gearbox
- Thread starter cragz200
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Series 3 is a s reg 1978 with only 50,000 done been parked up for 3 yrs put a battery on her and up she went. Could i change engine and box or would this be a mistake as series 2 is not 2a but 1961 august series2 bettter keep original?
Ta Craig
90truckcab
Well-Known Member
- Posts
- 4,739
- Location
- staffordshire
g/box x-members are different int they ! better off just doing hubs and overdrive,
90truckcab
Well-Known Member
- Posts
- 4,739
- Location
- staffordshire
this is what box yer should have in yer series 2
big dave2
New Member
- Posts
- 637
overdrive should be no bother ,take black plate off (previous photo) undo nut,remove cog ,fit odrive cog ,allways use new lock washer,fit new washer and nut ,do up tight to correct torque,gasket ,then odrive ,all done no bother,,,howzat,,,,,now comes the tricky bit,fit bracket on top of t,box ,buy hook or buy crook cut hole in side of p,shaft tunnel and fit lever and linkage ,this is the worst job and is A,P,I,T,A,but take your time ,persevere and all will be well,you will find odrive makes a HELL of a difference,,,,all the best ,,,dave
big dave2
New Member
- Posts
- 637
IM almost sure siii engine and box will swap with a sii,,cos i have siii diesel engine + siia gearbox in my siii,it fits no bother,props are right length ect,it was in when we bought it,the motor needs a new chassis now we"ve got that + another siii for spares with really good 5 bearing engine and box which is going in when we get a chance,,,,dave
