Series 3 SU carb conversion

sinnalegin said:

Hello
You have helped me before and I am hoping you can help me again.
I have bought an SU conversion kit for my Series 3 Lightweight but I am having trouble sorting out the linkage since the instruction sheets are very dark and not clear. I have to remove the bracket from the bulkhead support. Is the pivot assembly with the shortened arm then bolted back on through the top hole left by the bracket? Can anyone send me some close ups of the pivot assembly and the linkage. I would be very grateful. Thanks.
Nigel

Click to expand...

sinnalegin said:

Hello
You have helped me before and I am hoping you can help me again.
I have bought an SU conversion kit for my Series 3 Lightweight but I am having trouble sorting out the linkage since the instruction sheets are very dark and not clear. I have to remove the bracket from the bulkhead support. Is the pivot assembly with the shortened arm then bolted back on through the top hole left by the bracket? Can anyone send me some close ups of the pivot assembly and the linkage. I would be very grateful. Thanks.
Nigel

Click to expand...

Turboman said:

I don't have any pictures, but seem to remember that you need to use a cable instead of the rod linkage with SU carb.

Think @Colthebrummie or @kermit_rr might have SU on a Series.

Click to expand...

kermit_rr said:

I do, yes. Made up an adapter to the manifold so it sits at about the right angle, limited by the bonnet closing then made a bracket and nobbed about with the linkages so would work with the cable

Click to expand...

Colthebrummie said:

I dont have a SU carb, mine is a Zenith. I looked at the conversion once cos I do like SU's but it seemed to much of a faff and I decided keeping the old bus as original as possible was preferable to me. Any job that takes longer than an hour is too much
for my limited attention span

Col

Click to expand...