Series 1 - Help to get this started

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Series1LandyNewbie

New Member
Posts
9
Location
Gloucester
Hello,

I have recently inherited a Series 1 Landrover (1957) and need some help.

The Landrover has been stood still for the past 20 years and I have tried to see if it will start and nothing.

I have changed the battery and I have lights working wiper blades, but nothing coming from the engine.

I thought as a minimum the engine would try and turnover, but the starter button doesn't seem to do anything (no sounds)

Suggestions on steps needed please.

I have tried the crank handle and the engine does turn, so I know it's not ceased.

engine photo attached
 

Attachments

  • 55714613-C805-4092-9A74-D9AB0E3DFB91.jpeg
    55714613-C805-4092-9A74-D9AB0E3DFB91.jpeg
    84 KB · Views: 106
Usual old car first steps: check for spark, check for fuel flow.
Ref starter not turning, if the solenoid is not clicking when trying to start, check if it is getting power.
 
Last edited:
Have you got a DMM?...you will need to sysematicly check every wire from battery to dash and down to starter if everything has a 12v reading pull the starter off and give it a good clean on the bench and test it before re-fitting if working...
 
Positive earth in those days , worrying about the engine not starting is the least of your worries I personally would be checking the chassis and bulkhead for corrosion
 
Hello,

I have found out the issue and it’s the ignition coil.

I’ve been told it’s the old type for a series 1.

Any recommendations on where to get one from?

link to item if possible.
 
Back
Top