Ser III gearbox in a IIA
- Thread starter s.chick
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 83,296
- Location
- Embasinga stocæ
I believe that it will. Mite have to check on which clutch tho.
oil dripper
Well-Known Member
- Posts
- 5,659
- Location
- Here i think
6 cylinder enjun or 4 cylinder enjun? late 2a or early 2a it meks a difference ya know
- Posts
- 83,296
- Location
- Embasinga stocæ
arrrr Jim lad - good point tha Drippy.
raise:
raise:
andyb66
Well-Known Member
- Posts
- 1,795
- Location
- Middle of Salisbury Plain, Wiltshire
Clutch release mechanism is different as is the slave cylinder location.
Yes as above ^^^ check the clutch too. One is deeper than the other....can't remember which way round (in terms of late/early)
HTH
Yes as above ^^^ check the clutch too. One is deeper than the other....can't remember which way round (in terms of late/early)
HTH
oil dripper
Well-Known Member
- Posts
- 5,659
- Location
- Here i think
well gissa clue then
oil dripper
Well-Known Member
- Posts
- 5,659
- Location
- Here i think
parently itsa 1962 series 2a which is avin a 5 bearin 2 1/4 doosil fitted,will a series 3 box fit this :doh::frusty:
andyb66
Well-Known Member
- Posts
- 1,795
- Location
- Middle of Salisbury Plain, Wiltshire
Probably worn bearings. They are rebuildable. You can get a 'recon kit' from LEGS.
fenby1976
New Member
- Posts
- 1,036
- Location
- West Wales
Don't bin a late 2a gerbox!! They are the strongest of the series gearboxes and are very simple and usually cheap to repair. Before stripping the whole thing down, try replacing the detent springs: They cost pennies. I would not advise just jumping in and buing a recon kit if the detent springs don't sort the problem. Strip it down first and find out what's wrong, get a parts catalogue, make a list of the part numbers of the parts that are worn out then order them.
Last edited:
