Rumbling vibration mystery

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

RealBeale

Active Member
Posts
532
Location
Birmingham
Hi.
I've had a rumbling noise and vibration for the last few months that I cannot get to the bottom of. It felt like a drive shaft failure so I replaced what I thought was the offending shaft to no avail. Anyway I've now changed all 4 drive shafts, the gearbox and swapped over the transfer box with a known good one , all to no avail. The symptoms give the exact same feel as a driveshaft failure. The prop has been checked and is fine but we fitted another to eliminate that too.. Cannot think of what else it might be.
 
Hi.
I've had a rumbling noise and vibration for the last few months that I cannot get to the bottom of. It felt like a drive shaft failure so I replaced what I thought was the offending shaft to no avail. Anyway I've now changed all 4 drive shafts, the gearbox and swapped over the transfer box with a known good one , all to no avail. The symptoms give the exact same feel as a driveshaft failure. The prop has been checked and is fine but we fitted another to eliminate that too.. Cannot think of what else it might be.

I had something like that. Found rear diff oil low, topping up did not help but replacing bearings fixed it. With drive shaft off and back wheels off the ground I could feel it in the half shafts.
 
Hi.
I've had a rumbling noise and vibration for the last few months that I cannot get to the bottom of. It felt like a drive shaft failure so I replaced what I thought was the offending shaft to no avail. Anyway I've now changed all 4 drive shafts, the gearbox and swapped over the transfer box with a known good one , all to no avail. The symptoms give the exact same feel as a driveshaft failure. The prop has been checked and is fine but we fitted another to eliminate that too.. Cannot think of what else it might be.

What model FL is it? Didn't you get an FL2?
 
I had something like that. Found rear diff oil low, topping up did not help but replacing bearings fixed it. With drive shaft off and back wheels off the ground I could feel it in the half shafts.
I'll let my mechanic know as he's convinced it's steering related.

What model FL is it? Didn't you get an FL2?
You're right , I have an i6 F2. However this is my F1 Td4. I wrote the post at work on my tablet, for some reason wouldn't let me use the function. Every time I tried to put in F1, it just skipped to the text box.
So just so there's no confusion (which is my fault for using said tablet) here's a pic of my troublesome Td4.
SAM_2653.JPG
 
Have you tested the VCU? How are the VCU mounts? Are they parallel with each other and at 90° to the VCU shafts?
 
Yes mounts were tested and are fine. Been on for less than 2000 miles and were not cheap , around £80 each IIRC.
Basically it was an immediate thing. It didn't appear over time or get worse. Just drove home from the MOT in October and as I accelerated suddenly got this noise and vibration - just like a drive shaft failure. Got worse on acceleration and died off when coasting.I've had several d/s failures and immediately thought "here we go again". I've taken it to my mechanic who's had it for about 7 weeks now.
 
My V6 developed a vibration suddenly after I gave it a boot full out of a junction. It vibrated under acceleration from then on. I think it was the gearbox causing it, as it began leaking from the drive shaft. I changed the drive shafts and box seals. The vibration remained however. It was the box or IRD, bit I never identified the actual problem before I sold the car.
 
I have had a rumble that is intermittent, N/s can find no problems, had it checked out by a trusted mechanic, he heard the noise once.

The brake caliper on N/s sticks, attempted freeing it 3 times now so replacing it, hopefully that will sort it.

Had this same problem on mine earlier this year, re-furbished caliper, new pads and disc and all good. Perhaps the same for the OP's motor?
 
Last edited:
Quick update.

Now driven vehicle on a 265 mile trip, since replacing sticky caliper no noise at all.

Incidentally we also changed turbo at same time as it was leaking oil and did not want to risk a runaway engine. Can't see that the turbo would have created the intermittent noice, but thought worth a mention.

Happy new year
 
Back
Top