Rear work light wiring route

I've got the wires to my front light bar nice and neat under the windscreen seal. Now I want to add a couple of work lights either side of the back door, on CB aerial mounts. I cant find an example of or think of a neat route for the wires to go. The lights are only 10W LEDs, so take about half an amp each.

Any suggestions?

Tuck em under the gutter and in behind the door seal

When looking at the problem again I noticed a gap in the body work. After taking a few panels off that I didn't need to, I figured out this came out just under the light cluster. I needed to take the light cluster out to get the wire past the rubber seal. The wire then goes under the car and back in through the grommet with the bumper light wires.



Once the rain stops I can finish wiring them up.



I think the light bar wiring turned out quiet neat. Just waiting for the other LED lights to arrive. Wiring good for over 300 watts, but I'll only be using 56.