nick the gin
Member
- Posts
- 91
- Location
- tunbridge wells
Freelander 1 will a Freelander 1 face-lift 2005 prop and diff fit Freelander 1 2002
Both td4 ?
Both td4 ?
Rear propshaft
- Thread starter nick the gin
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Nodge68
Well-Known Member
- Posts
- 32,504
- Location
- Near Newquay
Yes, mechanically they are the same vehicle.
nick the gin
Member
- Posts
- 91
- Location
- tunbridge wells
My next question is on the door check straps front doors is it bolted on the inside of the shut where the pin goes as mine are loose ? Not the door end the shut end
Nodge68
Well-Known Member
- Posts
- 32,504
- Location
- Near Newquay
Unfortunately they are welded inside the box section, and the welds have been known to break. The reason is down to the check strap not moving freely enough, which over time puts enough strain on the welds for them to fail.
nick the gin
Member
- Posts
- 91
- Location
- tunbridge wells
thanks again
one last thing are the head linings the same pre and post fl1
Nodge68
Well-Known Member
- Posts
- 32,504
- Location
- Near Newquay
Yes, but they're not difficult to re-cover in new fabric either. There's loads of guides on how to re-cover on line.
nick the gin
Member
- Posts
- 91
- Location
- tunbridge wells
ffs just took dash out to change bulbs and now the remote fob wont work ? any ideas ?
Nodge68
Well-Known Member
- Posts
- 32,504
- Location
- Near Newquay
Check the connection to the receiver module, which is mounted on top of the Ipack.
nick the gin
Member
- Posts
- 91
- Location
- tunbridge wells
i drove the car with no dash in it and thats when i found its not working by trying to lock the car with no dash in it , is the i pack the dash ?
andyfreelandy
Well-Known Member
- Posts
- 5,155
- Location
- Devon
Receiver is black box fits on brackets on top of instrument module with the speedo and rev counter in a case.
I pack is the instrument module and electronics. So if the 'dash' was out then the receiver is probably out too !!
You failed to mention a large part of the car electronics was left removed!! Sounded like you had fixed lamps put it back together and remote had failed !!
I pack is the instrument module and electronics. So if the 'dash' was out then the receiver is probably out too !!
You failed to mention a large part of the car electronics was left removed!! Sounded like you had fixed lamps put it back together and remote had failed !!
Last edited:
nick the gin
Member
- Posts
- 91
- Location
- tunbridge wells
sorry yes , remote is sending signal , do you think coz i drove it without the modules connected that its forgotten the signal from the remote ??
Nodge68
Well-Known Member
- Posts
- 32,504
- Location
- Near Newquay
It might need re-syncing, but the CCU can't forget the remote code.
To synchronise the remote, you have to press the lock or unlock button a few times in short succession.
nick the gin
Member
- Posts
- 91
- Location
- tunbridge wells
nope still wont work ? is there a fuse that may of blown ?
Similar threads
