Rear diff oil seal

Martyn110 · Apr 27, 2013

Hi guys just bought a kit to replace the oil seal on my Salisbury rear diffon my 110, is it a easy job or worth sending it into the garage ? Bb
Cheers

jamesmartin · Apr 27, 2013

seal needs a tool to fit it without damage and pinion nut needs tightening extremely exactly to give the right preload to pinion bearings ,tool needed to hold flange as crushing spacer takes some force

RobertOHare · Apr 28, 2013

jamesmartin said:
seal needs a tool to fit it without damage and pinion nut needs tightening extremely exactly to give the right preload to pinion bearings ,tool needed to hold flange as crushing spacer takes some force

i used the old seal to knock the new one it and its normaly in enough when the old seal is sitting flush then just pop the old one off seemed to work fine for me?

and as far as how tight it was i done it FT recon i should pop the shaft back off and tighten again?

jamesmartin · Apr 28, 2013

feel it ,see if theres any end float or feels too tight or notcy when you rotate it

RobertOHare · Apr 28, 2013

i am feeling a little smidge of vibration at about 50 ish mph but dont know if this is related ?

Rear diff oil seal

Martyn110

Active Member

jamesmartin

Well-Known Member

RobertOHare

New Member

jamesmartin

Well-Known Member

RobertOHare

New Member

Similar threads