RCA routing for amp

just picked me up a cheap (aka free) active sub for me fender

power cable routing isnt an issue, just trying to work out the best way to route the RCA cables.
do I take them through the bulkhead and underneath, or some other way, the A pillers are a bit full, the drivers one having 4 spot cables in there, the passenger the rear speaker cables, the factory cables that go up there, and the rear washer tube.

or i could route downwards, threough the bellhousing cover and underneath that way, main thing is any holes drilled will need to take an RCA plug.

when I did mine I went through a pre drilled water escape hole in the rear tub and along the top of the bell housing making sure that it does not go near leavers springs etc and also bit of gaffer tape to the top of the bell housing and up the bulkhead in in the back of my head unit it looks all tidy and is not hard to undue at any point good luck

timtheenchanteruk said:

or i could route downwards, threough the bellhousing cover and underneath that way, main thing is any holes drilled will need to take an RCA plug.

Click to expand...

Just cut the plugs off, run the cable then solder on new RCA plugs.

Make sure you use grommits in any holes you make