Mikewilliams
Active Member
- Posts
- 194
- Location
- Anglesey
What gets mounted onto these brackets on the front of the crossmember?
R380 gearbox crossmember brackets
- Thread starter Mikewilliams
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 11,020
- Location
- North of the Wall
My new gearbox cross member didn't have them on.
Mikewilliams
Active Member
- Posts
- 194
- Location
- Anglesey
Mmmm, this is a new one.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
for fitting an under tray
Mikewilliams
Active Member
- Posts
- 194
- Location
- Anglesey
Thanks james,
Well i wont be fitting an undertray so i’ll be using them as mounts for my exhaust
Well i wont be fitting an undertray so i’ll be using them as mounts for my exhaust
- Posts
- 7,789
- Location
- East Midlands
Are you sure you want the exhaust to hang that low? It might be vulnerable to fouling on obstacles, or even kerbs and speedbumps. My exhaust hangs on brackets that go on the upper bolts of the detachable crossmember which enables it to sit higher up between the chassis rails out of the way.
Mikewilliams
Active Member
- Posts
- 194
- Location
- Anglesey
I wouldn’t be hanging them lower. I will make a bracket that mounts onto those brackets that hold the exhaust more or less the same level as the crossmember
- Posts
- 7,789
- Location
- East Midlands
Ah, I see. Should be OK then, if you get the exhaust routed above the crossmember.
