R380 Clutch alignment tool measurements?
- Thread starter Zord
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
spigot 22mm same as all diesels including td5,worth rining around reconditioners as i cut end off input shafts for gear box lt77.r380 aslong as diesel will do
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
you only need two spigot and clutch center splines which i dont know offf hand could tell you tomorrow or perhaps someone has diesel 77 ot r380 and could measure inpushaft splines
wiltshire landyman
I’m back
- Posts
- 15,062
- Location
- salisbury plain wiltshire
we used a long socket when we done ours simple but it worked
Boris113
Well-Known Member
- Posts
- 1,356
Did my lt77 clutch last week using an old lt77 input shaft...worked a treat. I don't know if lt77/r380 is the same size but if so i can take some piccys/measurements of the lt77 one when i'm in the workshop tomorrow evening? 
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
lt77 and r380 are the same size so if you measure diameter of spline on shaft that would be the 2 measurements he needed
Boris113
Well-Known Member
- Posts
- 1,356
Hey Zord, apologies but i didn't make it down to the workshop today. i'll be heading down tomorrow afternoon so shall check then.
Harry
Harry
