dean68uk
Active Member
- Posts
- 525
- Location
- Gosport Hants UK
Hi my psi powerbox seems to have stopped working. should any of the box internal LEDs be on. there is a green and a red one. thanks
psi powerbox led
- Thread starter dean68uk
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
dean68uk
Active Member
- Posts
- 525
- Location
- Gosport Hants UK
Still stuck. Does anyone have a psi box fitted, that they could have a quick look please. i have no leds on at the moment.
- Posts
- 16,475
That could mean no power getting to it....my first check would be to check the connections and for power first.
dean68uk
Active Member
- Posts
- 525
- Location
- Gosport Hants UK
Hi I have checked all the connectors and pipe to the map sensor. I have open the psi box to check the leds and they are not lit. No broken wires either.
Datatek
Well-Known Member
- Posts
- 43,999
- Location
- Near Poitiers SW France
Try asking PSI. It sounds like the old type analogue box from your descritption.
dean68uk
Active Member
- Posts
- 525
- Location
- Gosport Hants UK
I have emailed psi. The box has a chip inside and a green and a red led. it was working well until today. My dse is a 99 with egr. The psi box has 4 connections, 2 between the map sensor and the other 2 between the fip. the map pipe is clear and the maf is clean too. Just wondered if the leds were for diagnostics and should they be on
dean68uk
Active Member
- Posts
- 525
- Location
- Gosport Hants UK
Can you clean the MAP sensor and how can you measure the valve? Does the MAP sensor fail?
Datatek
Well-Known Member
- Posts
- 43,999
- Location
- Near Poitiers SW France
Everything can fail, but not seen many failures reported. Is the pipe from the manifold to the MAP sensor in place with no splits at the ends?
I would expect that the green LED in the PSI box should illuminate, but I'm only guessing
dean68uk
Active Member
- Posts
- 525
- Location
- Gosport Hants UK
I too think the green led should light but could be wrong. I have checked the MAP sensor and it gives the correct voltage change like the checks on youtube show. The pipe is new with no splits and clean. The MAF is also clean. The box connecttions are good too. I have emailed PSI, but was hoping someone with a PSI box could check their box. Is the rimmer one the same too?
DeRanged Rover
New Member
- Posts
- 107
- Location
- London
Will check tonight but if I remember correctly the Rimmer one doesn't have any LEDs.
dean68uk
Active Member
- Posts
- 525
- Location
- Gosport Hants UK
Many thanks for that, any help is good.
