Propshaft IRD

C

Chris_68

Member

Full Member

Posts

66

Location

Sweden

• Yesterday at 07:38

• #1

Hello,

A stupid question, I have replaced VCU bearings and now notice a slight vibration I don't remember I had earlier. Should the arc shaped washers (see attachment) be placed in specific positions?
I only marked the prop shaft and position related to IRD and diff...

/Chris

 

Attachments

• 
  LZ.png

  474.5 KB · Views: 12

Arctic2

Well-Known Member

Posts

2,937

Location

Westmidlands

• Yesterday at 07:58

• #2

Hi Chris.
The Arch shape washers can go into any place but always nice to put back where they came from.

1

2

Check the rear universal joints at the rear drive shaft area to see if they are ok

3

 

C

Chris_68

Member

Full Member

Posts

66

Location

Sweden

• Yesterday at 08:21

• #3

Thanks!

They are a bit annoying to fit so I don't think it is not worth removing the washers ATM.
The U-joints are all new, will drive a few miles and then check everything again.

/Chris

 

Hippo

Lord Hippo

Posts

55,220

• Yesterday at 08:31

• #4

Make sure the vcu bearings are fitted 90 degrees to the vcu.