P
Pieter Vroom
Guest
I would like to remove the PTO cover (Discovery 200TDi) to have a look at
the condition of the output shaft.
However, I is stuck one with liquid gasket type stuff, which seems more like
superglue than sealant. I have tried getting a skrewdriver between the lid
and the transferbox, but had no success.
Any ideas of how to get if off? Would heat soften up the sealant? Or would a
blowtorch to more damage than good?
Grateful for any advice,
Pieter
the condition of the output shaft.
However, I is stuck one with liquid gasket type stuff, which seems more like
superglue than sealant. I have tried getting a skrewdriver between the lid
and the transferbox, but had no success.
Any ideas of how to get if off? Would heat soften up the sealant? Or would a
blowtorch to more damage than good?
Grateful for any advice,
Pieter
