Pressure build up in RRC

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

DC_

New Member
Hi gang, I recently changed over my expansion tank due to a seam cracking on it and thought that was the end of my worries, Today after a little fun offroad and a drive back along the bypass i noticed for the first time since i've had the car the temp gauge just over the half way mark.
When i got home i checked under the hood and there seems to be excess pressure building up in the cooling and it forced water over the top of the expansion tank (dont ask me where it came from)
Any suggestions? Too much water in it? Thermostat? Not really too clued up on the techy side but if made easy i will give it a go. Hoping it's nothing too serious as i have a run on in may.

Help

DC
 
Pressure in the water system could be a sticky thermostat, but before disturbing it check your oil condition, take the oil filler cap off and look at the inside of the cap is it white and furry, start the engine with the cap off, hold your hand over the oil filler cap hole, do you feel pressure coming out from it, if you do then you have a blown head gasket, if the oil is fine and you don’t feel pressure you may just have a problem with the thermostat or an air lock.
 
UPDATE:

Cleaned all the radiator free of any mud that may have been preventing the good flow of air, Changed over my expansion tank cap as it might have been faulty and not venting at about 15psi, Today i had the gases checked in the cooling system to see if there was traces of fumes which may suggest head gasket, got the all clear, Seems to be running ok now but i am just going down to check the water level is at half way since my run out today/ Make sure it's still not losing water.

Thanks for the help, Oil was ok also nice and clean still from march' service, Oil cap clean, No smell of sweetness in the exhaust fumes that also may suggest coolant leaking into the system.

I'll keep a wee eye on it mind

DC
 
Back
Top