Points alignment

SimonM · May 3, 2006

Just fitted a new set of points to my Series 3 (Ducellier distributer) and I noticed that the contacts don't line up properly (see attached picture). Is this usual? What have I done wrong now?

Cheers,
Simon

ormus · May 3, 2006

dont think theres anything you can do wrong fitting a set of points. they just look a bit dodgy. if you were pedantic you could change em.
but i would just leave em in and carry a spare set just in case.
(dont forget the tools).

SimonM · May 3, 2006

OK thanks.

I might try opening up the hole where the adjustment screw goes a bit to see if I can align them a bit better.

Wesley Pegden · May 3, 2006

They're OK chap. These things aren't an exacting science. The little feckers clatter about in all directions. As long as yer gap is summat like you'll be OK.

Regards WP.

Points alignment

SimonM

New Member

Attachments

ormus

New Member

SimonM

New Member

Wesley Pegden

Well-Known Member

Similar threads