Please Help !!
- Thread starter Leetdi
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Diesel Do
Well-Known Member
- Posts
- 5,213
- Location
- Nottingham
Front prop turns when stationary? If it does then you've broken something in your front axle, diff, cv, half, shaft etc! Try it in diff lock. It should put the drive to the rear axle too but you'll only be two wheel drive and may get orrible noises out the front axle depending on what's broken,
DD
DD
Last edited:
Fatboy11
New Member
- Posts
- 1,074
- Location
- Thatcham, Berkshire.
Take the front prop off and use difflock.
Diesel Do
Well-Known Member
- Posts
- 5,213
- Location
- Nottingham
Read my post! Front prop should not be able to turn when stationary! It should make the wheels turn, soooo something is broken in the front axle! If you put it in diff lock it will put drive to the rear wheels as I said in my first post and it will drive but you will still have a broken front axle!!!
DD
DD
Diesel Do
Well-Known Member
- Posts
- 5,213
- Location
- Nottingham
You only say you've gone from high to low! That's not diff lock???
Diesel Do
Well-Known Member
- Posts
- 5,213
- Location
- Nottingham
High low is forward/backward on the lever diff lock is sideways!
DD
DD
Diesel Do
Well-Known Member
- Posts
- 5,213
- Location
- Nottingham
You have high neutral low in open diff move it sideways and you have the same three in diff lock!
DD
DD
Lowlight
Active Member
- Posts
- 487
- Location
- North Wales
To lock the diff you need to push the hi - lo lever to the left
Diesel Do
Well-Known Member
- Posts
- 5,213
- Location
- Nottingham
If its never been used its probably pretty seized, work it side to side and make sure it's not in the neutral position
DD
DD
buckshot
Well-Known Member
- Posts
- 9,841
- Location
- right yer!
ok went all way to left and up and down and sill no drive it tries to inch forward but get nowhereSTRESSED LOL
could be your lever has slipped on adjustment
