Pedal Rubbers... Dazed and Confused!

Can anyone advise of the correct P/N... I have an early 1984 90, which seems to have a weird and wonderful mix of pedals?

Accelerator pedal - is standard slim-Jim type 90/Defender, so no worries there
Clutch pedal - is the old-school Series type with tang'd pad rubber, got that sorted
... However, the brake pedal is a large'ish affair with a slip on rubber cover - approx 60-70mm square - anyone advise of the correct P/N? Paddock Spares must think I'm in the business of collecting these for fun!

The joys of an early model!

Thanks in advance.

Hmmm. I have an early 1985 model, it uses the standard defender slip on set - the brake and clutch pedals are the same. Sounds like your clutch unit has been changed at some point. You could just buy a set to "cover" the accelerator and brake pedals. If you only need the one - paddocks PN 61k738

As Zeaphod said, 61k738. This is the rubber type with a lip around the edge that goes over the pedal. I believe your setup is correct - the clutch would have had the clip on Series type and the brake the rubber -lipped type (61k738).
I believe both types of pedal rubber will fit both brake and clutch.

Thanks guys... really appreciate that. I'll get a set of the slip on type sorted (as per the P/N suggested), which should do the trick.

part number help for future reference!

http://www.retroanaconda.com/landrover/2009/12/land-rover-defender-90-parts-book/

Superseded part number is SKE500060P.