part number needed

bluehaze · Jan 29, 2012

Can't find this anywhere....:doh:

Back of the power steering pump are two hoses. One uses a jubilee clip and the other is bolted on between two copper washers. As I'm replacing the seals I'll need to replace the two copper washers when rebuilding.

What's the part numbers of the washers?

Station House · Jan 30, 2012

Pages 455 onwards are the exploded diagrams, but struggling to see the bit you want

http://www.retroanaconda.com/landrover/parts_books/110/5_axles_suspension_steering_p398-471.pdf

James?

bluehaze · Jan 30, 2012

Hi James,

Thanks for the diagram - I've already checked it and it doesn't show either the banjo bolt or the copper washers.

Don't want to strip it down until I've got all the bits ready to rebuild it.

Drookit Dug · Jan 30, 2012

Are the bits you need not 'bundled in' with the seal kit that comes with the pump but orderable separately?
RTC5935 - Kit seal (NTC8287) or
STC1633 - Kit seal (NTC9070)

Page 200 of SH's link I think

jamesmartin · Jan 30, 2012

thats mr station you need to thank ,to be honest you can reuse them, but new ones are rtc5675 dowty washers

jamesmartin · Jan 30, 2012

Drookit Dug said:
Are the bits you need not 'bundled in' with the seal kit that comes with the pump but orderable separately?
RTC5935 - Kit seal (NTC8287) or
STC1633 - Kit seal (NTC9070)

Page 200 of SH's link I think

no just pump seals

bluehaze · Jan 30, 2012

Sorry and thank you SH.

As usual, thanks James - as I'm stripping the pump all the consumables will be replaced and then hopefully it will be ok for another twenty years!!!

bluehaze · Jan 30, 2012

Ordered.

part number needed

bluehaze

Well-Known Member

Station House

Well-Known Member

bluehaze

Well-Known Member

Drookit Dug

Active Member

jamesmartin

Well-Known Member

jamesmartin

Well-Known Member

bluehaze

Well-Known Member

bluehaze

Well-Known Member

Similar threads