Pads help
- Thread starter Cirrus
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
thought it was mine!
New Member
- Posts
- 8,236
did you put pads in the right way round??
jonny mac
Active Member
- Posts
- 240
- Location
- north wales
Have you tightened the wheel bearings to much? I've been told they can plane themselves if the adjuster nut is too tight
Lol yes!
How much is too much?
- Posts
- 4,201
- Location
- North Norfolk
I'd say you've overtightened the bearings aswell.
DiscoPol
Well-Known Member
- Posts
- 6,376
- Location
- The Land of Po
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
they have two nuts as they shouldnt be tight at all ,just remove freeplay and no more carefully by hand so you can just feel play removed
- Posts
- 4,201
- Location
- North Norfolk
have a look at Busters thread (the wise old sage of LZ 
) http://www.landyzone.co.uk/lz/f41/rear-wheel-bearings-renewed-58851.html
) http://www.landyzone.co.uk/lz/f41/rear-wheel-bearings-renewed-58851.html
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
but dont put inner seal in wrong way round
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
in which case were pistons tight to push back
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
tight ?,pads right way round?
