Discodevon
Well-Known Member
- Posts
- 1,444
Hello Guys last year I had a new rocker gasket fitted along with the Pace automotive sealed injector loom however oil is getting passing through the o rings (not the wiring itself) anyone else had this issue?
Pace automotive injector loom, oil getting past the o rings and leaking
- Thread starter Discodevon
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 2,097
- Location
- East of England, UK
No but I've sold about 60 of these looms with no issues reported. So you are not getting oil "in" the loom, just around outside of the plug?
Discodevon
Well-Known Member
- Posts
- 1,444
Hello mate that is correct, it’s not in the pins but in the plug kind of thing, then running down the outside of the loom and on what looks like the alternator
- Posts
- 2,097
- Location
- East of England, UK
Those O rings are NYX100080. It's best to use something like Molycoate 55 O ring grease on them as it slightly swells the O rings.
If you contact Dan at Pace he may replace it, or send you some O rings. He's pretty helpful.
If you contact Dan at Pace he may replace it, or send you some O rings. He's pretty helpful.
Discodevon
Well-Known Member
- Posts
- 1,444
Thanks very much Tom for your input the o ring grease such a good idea as well! I contacted them already and they going to send me a new one, so pace seem quite helpful and I’ve just been unlucky kinda thing
Discodevon
Well-Known Member
- Posts
- 1,444
Thanks very much Tom for your input the o ring grease such a good idea as well! I contacted them already and they going to send me a new one, so pace seem quite helpful and I’ve just been unlucky kinda thing
Similar threads
