Hope I'm posting in the right area now new member and new rover owner I'm having problems with my eas on 2001 range rover vogue 4.6 I think I've found the culprit a melted pipe but looks a nightmare to get to as it is above rear axel and really awkward inwas just wondering if anyone had any experience of changing these and where they run to and from many thanks in advance
P38 eas
- Thread starter Smally 1
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
brianp38dse
Well-Known Member
- Posts
- 20,093
- Location
- heathrow
They are quite bendy so you can pull them down a bit and the fitting are push fit, best to shanfer the end with a pencil sharpener
If its the one that goes to the tank you can route it round the front of the car.
If its the one that goes to the tank you can route it round the front of the car.
Datatek
Well-Known Member
- Posts
- 45,015
- Location
- Near Poitiers SW France
The over the rear axle one goes to the tank. You can reroute if you wish or tape a new length of air line to the end of the old and try to pull the new one into place.
