P38 1996 ECU Pin 1

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

MajSkollie

New Member
Posts
46
Location
Namibia
Good Day

I would like to know where to start looking for this problem.

"No voltage at ECU Pin 1 when Ignition on"

I have all sort of funny problems with my Rangie and would also like to know if this can be related.
 
Irishrover

It is an 1996 Range Rover 4.6 HSE.

symptoms : The car jumps between gears (Auto). i parked the car next to the road, put it in Neutral, give it a nice ref, Then back in to drive, no problem for 5 minutes, then again, gears no gears... Jumps around.

The error code , or print screen is as follow:

Code: 1.2.8 No voltage at ECU Pin 1 when ignition on

Regards
 
I will have a look. thing is when I revved the Rangie, things seems to better...

Could this be a problem when the fuse box under bonnet has gone, or burn marks on it.
 
aaa dis 'n verassing... :)

Yes the oil in the Gearbox is fine. There was an oil service done less than 5K kilometers back.
 
aaa dis 'n verassing... :)

Yes the oil in the Gearbox is fine. There was an oil service done less than 5K kilometers back.

Ja Boet,so maak mens!:D

You also mentioned you have "odd things happening" with your RR.This is indicative of 1) Defective battery/charging circuit
2) " fusebox under bonnet
3) " earth point/battery/alternator cables.
These vehicles are very senstive to the above and can generated odd problems ,including odd random fault codes of which your code may be a symptom.
If you dont have "Rave" ,do a search for "greenoval" and download from that site.This will give you the info regarding Ground points etc.
 
More Oom JohnP38 :)

I just spoke to Rover Land in SA, and according to him, the message is related to the Pin 1 in the ABS Accumulator Switch.

I do not know where this switch is..... :-(

He also mentioned that with the gears jumping up and down could be the Selector switch on the gearbox.
 
Back
Top