roddy4
New Member
- Posts
- 664
- Location
- banbury,oxfordshire
could someone please tell me how to get the abs sensor out at the driveshaft end,where it goes on to some splines,is it a push fit or is it held on by some other means.
p38 1995 2.5 diesel abs sensor
- Thread starter roddy4
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Datatek
Well-Known Member
- Posts
- 45,015
- Location
- Near Poitiers SW France
It is I believe held in by the standard LR method, corrosion!
- Posts
- 58,170
- Location
- Preston Lancs.
Yes it's a push fit and a crowbar removal. Try twisting it out.
ianmenai
New Member
- Posts
- 34
- Location
- Cardiff, UK
The ABS sensors are held in by a metal sleeve! This usually corrodes as is normal on a car that is encouraged to get mud on it!
The ABS sensor is a fairly delicate device so be VERY careful as to how you get it out! Chances are you will wreck it and have to replace it, not cheap! You will need a new bush when fitting a new or replacing the old, not expensive! When inserting it make sure that it IS touching the teeth on the shaft. It will move back a tiny bit when the car first moves off and then it is set.
Download the Microcat parts manual (GreenOval.com) and then you will see the component parts in all their glory!
The ABS sensor is a fairly delicate device so be VERY careful as to how you get it out! Chances are you will wreck it and have to replace it, not cheap! You will need a new bush when fitting a new or replacing the old, not expensive! When inserting it make sure that it IS touching the teeth on the shaft. It will move back a tiny bit when the car first moves off and then it is set.
Download the Microcat parts manual (GreenOval.com) and then you will see the component parts in all their glory!
