Oil in water again!!! help

S

smb1

New Member

Posts

6

• Jan 20, 2011

• #1

Hi, just had the head skimmed and a new head gasket on td5 and there is still oil in water which within a matter of 30 miles dipstick goes from full to low level.


Any suggestions???

 

Bromsgrove Defender

Well-Known Member

Posts

5,759

Location

Out to lunch

• Jan 20, 2011

• #2

smb1 said:

Hi, just had the head skimmed and a new head gasket on td5 and there is still oil in water which within a matter of 30 miles dipstick goes from full to low level.


Any suggestions???

Click to expand...

Take it back to where you had the work done

 

Shifty1962

Well-Known Member

Posts

4,209

Location

The Winchester Club - Englandshire

• Jan 20, 2011

• #3

Assuming the face of the block is OK and the head gasket has sealed check oil cooler for internal leaks. The casting can crack which would leak coolant externally or the pressed steel heat exchanger can rust through if you dont run with the correct anti freeze and lets the oil enter the coolant. You wont see this unless you remove the cooler though.

 

S

smb1

New Member

Posts

6

• Jan 20, 2011

• #4

I also think its the oil cooler. will check and let you know.

thanks

 

S

smb1

New Member

Posts

6

• Jan 20, 2011

• #5

just found the problem , oil cooler is rotten and has hole. thanks shifty

 

Shifty1962

Well-Known Member

Posts

4,209

Location

The Winchester Club - Englandshire

• Jan 20, 2011

• #6

No worries - at least you know what the problem is. When you fit a new one make sure that you have the correct anti freeze as it contains corrosion inhibiters. I'd also flush and change the engine oil just in case any water got into the sump.