None starter

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Crazydave1967

Crazydave1967

Member
Posts
48
Location
Norfolk
Hi everyone
I've got a discovery 2 td5
Had a key snap in the ingintion. So took barrel off to work on the bench. Dissconected 3 wires. Got the piece of key out. Put all back together. Now won't crank over. Got all dash lights and fuel pump is working.but not starting. Anyone help plz
 
Hi. What if you give an unlock command with the fob then turn ignition to crank? ... didnt you disturb the connection of the remobilisation exciter coil ?
 
All plugged back in. Plus tryed different pushing of key fob still nothing. All lights on the dash. And fuel pump going. But no starter
 
So dont you hear anything when you crank it? not even a click? the red LED on dash is out ? It's only about unlock on the fob not other actions
 
Not the starter. Cause was working before I dissconected the barrel. Light flashing fast then every 2 second or so. Put key in to start light goes out. But no turning of starter motor
 
I undersood what's going on. If you are sure you didnt miss anything when you refitted the barrel check the harness on the switch which is attached to it's back. It's possible hat the crank wire to be loosened or something or the barrel's shaft doesnt turn tthe swicth enough
 
If no joy release the switch(pic), insert a flat head screwdriver in the slot and turn it with that to max, if still no crank see if the white/red wire at it's back is well connected... the fob must be close the the remobilisation coil(which is around the barrel) when you do that, evenually make sure that the coil is well connected...you can also try to bridge the brown and white/red wires just to make sure the circuit is OK

Ignition harness.jpg
 
Then bridge the brown - white/red wires with a piece of wire and if still no joy it's something coincidental, check the spade connector on th starter solenoid
 
Hi all
Just to let you know the discovery is up and running.
Turn out to be the truck had lost signal with the key and shut itself down but thank you all for your ideas.
 
You must log in or register to reply here.

Similar threads

Andrewoldold
M&S lights no crank / potentially immobilised?
Replies
1
Views
298
sierrafery
sierrafery
G
Discovery 2 TD5 Donor Conversion
Replies
17
Views
601
GTRekky
G
L
Intermittent starting issue.
Replies
4
Views
493
Anaconda
A
DollyBird
Engine disabled, keys not working, tried the guide “Re-synching the Range Rover P38 diesel engine with the Solved - BECM using a Nanocom” no luck
Replies
9
Views
1K
DollyBird
DollyBird
M
Classic Range Rover Suffix D Starting Issues - Advice required please
Replies
6
Views
778
Datatek
Datatek
Back
Top