No comms with EAS ECU

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Right I've established communication and replaced the RL height sensor. But now as soon as the eas unlock software is stopped the system immediately returnes SLOW: 35MPH and the system is again locked.

Eas unlock is reporting no errors and all ride height settings are different.

Any ideas?
 
customknight said:
Well it looks like the new sensor needs adjustment. So what is the correct disconnect procedure for eas unlock?

Many thanks in advance.
Click to expand...
Stop the software, turn the ignition off, unplug the cable, turn the ignition back on and there should be no message.
You don't adjust one sensor, you calibrate the heights for all 4 corners, adjusting one corner affects all the others.
You could try reading the EAS instructions at www.rswsolutions .com
 
Thanks for the advice. All sorted now. All I'm going to do now is to add manual valves inline so Incan blow the system up if it fails again. :)
 
customknight said:
Thanks for the advice. All sorted now. All I'm going to do now is to add manual valves inline so Incan blow the system up if it fails again. :)
Click to expand...
Not a good idea, just more places to leak. Keep a set of manual valves with in line connectors and pop the pipes out of the valve block to fit them if you have to. In 4 years I have never had a problem that has needed the valves even though I carry them and a 12 volt compressor,
 
You must log in or register to reply here.

Similar threads

JamesBB
P38A EAS again.
2
Replies
39
Views
2K
Datatek
Datatek
D
RSW EAS free version problem commination with car
Replies
9
Views
809
pwood999
pwood999
F
P38A Brake light is permanently on
2 3
Replies
57
Views
2K
Datatek
Datatek
M
Whats happened to Storey Wilson RSW Solutions
Replies
5
Views
1K
mousemat
M
Henry_b
P38A Nanocom problems
Replies
8
Views
972
pwood999
pwood999
Back
Top