steve2286w
Well-Known Member
- Posts
- 4,573
- Location
- monkeyangerland
Should these be oiled , greased or left as is before fitting
I’ll secure it properly this time
New speedo cable
- Thread starter steve2286w
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Should these be oiled , greased or left as is before fitting
I’ll secure it properly this time
Hicap phill
Well-Known Member
- Posts
- 16,320
- Location
- Wiltshire
Too much oil will track back to the speedo & cause a fault.
Grease may do the same.
Try a ptfe dry lube
Grease may do the same.
Try a ptfe dry lube
steve2286w
Well-Known Member
- Posts
- 4,573
- Location
- monkeyangerland
Thanks phil
Bobsticle
De Villes Advocaat
- Posts
- 27,632
- Location
- Manchester
I used one shot in mine. Pain to do but works a treat. I’ve had no trouble at the speedo end but just thought this was a gravity thing.
steve2286w
Well-Known Member
- Posts
- 4,573
- Location
- monkeyangerland
It’s in now , the bottom end was a bit rusty coloured so I put a bit of copper grease at that end
I was expecting a square end on cable , at gbox end it was oval
Not tested yet but I guess this might be easier to align than square
I was expecting a square end on cable , at gbox end it was oval
Not tested yet but I guess this might be easier to align than square
- Posts
- 10,472
- Location
- A bit sarf of Dorking
What? Just like that? I hate that job. Last time I did I had the floors and seatbox out and it's still the second worst job on that whole car. Clutch slave cylinder/stripped threads on the retaining bolts since you ask...
steve2286w
Well-Known Member
- Posts
- 4,573
- Location
- monkeyangerland
Mine was missing the top screw, but if it was then best to get that from middles seat cover , for the lower two the exhaust was getting in the way of my screwdriver so I used a 3/8 ratchet with extension and flat bit long enough to get past exhaust without hitting chassis peace of **** at gbox end , getting it to click in speedo took a bit longer , i Need to fix some clips to it , reason for changing it wrapped round front prop last week causing a bit damage
steve2286w
Well-Known Member
- Posts
- 4,573
- Location
- monkeyangerland
stripped threads in bellhousing ?omg How did you fix that
- Posts
- 10,472
- Location
- A bit sarf of Dorking
With helicoils and great patience. Most of the screw hole threads on the engine were in a similar state (thanks REME), but I had the luxury of fixing them before I put the engine back in.
