owensdad
New Member
- Posts
- 63
- Location
- lincolnshire
the red light flashes on the lpg switch but the gas will not switch over even when temprature is normal, any advice greatly appreciated
lpg
- Thread starter owensdad
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
njh2
Active Member
- Posts
- 623
- Location
- Lovely Shropshire...
Hi.
Is there any gas?
Is the pressure switch working?
Is there enough water in the system?
Are all the solenoids operating to allow gas to the engine?
Is there any gas?
Is the pressure switch working?
Is there enough water in the system?
Are all the solenoids operating to allow gas to the engine?
owensdad
New Member
- Posts
- 63
- Location
- lincolnshire
hi, thanx for your reply,
yes there is gas
yes there is water and the vapouriser is getting hot
how do i check the pressure sswitch and solenoids
ben.suffolk
Active Member
- Posts
- 186
- Location
- Longwell Green, Bristol, UK
Disconnect the solenoids, and put 12V across them. You should hear a good loud click / clunk type noise if they open.
I would imagine if you have the software the gas ECU should tell you what the fault is. You can generally get the software as a download, and the leads are pretty cheap on ebay.
I would check out the LPG forum over at lpgforum.co.uk, they are a friendly bunch, and always have good advice..
Ben
I would imagine if you have the software the gas ECU should tell you what the fault is. You can generally get the software as a download, and the leads are pretty cheap on ebay.
I would check out the LPG forum over at lpgforum.co.uk, they are a friendly bunch, and always have good advice..
Ben
