P38A lpg repair or replace

My lpg system has never worked since I have had tiny. I can't see anything obviously wrong so suspect dodgy wire somewhere I need to get a decent multi meter to test them as no power.

But as its an old system obviously a new system should be an upgrade has anyone done this how much of the old system can be reused injectors, tank, plumbing? As it's already in can a swap be done DIY just follows current setup layout?

Probably cheaper to get an expert to look at it?

Tank etc should be OK. Any idea what sort of setup is fitted?

It's an ag autogas sgi - sequential gas injection system

I've had 2 people look at it one said its an old system and we didn't fit so won't touch best replace it - spent less than 5 mins looking at tiny. Second said prob electrical issue, we can look at it but might be cheaper to have a go yourself first then bring it back we can service and check it over.

Back end stuff (Tank etc) can stay aslong as it is in good nick....

Front end can be changed...the only major issue is splicing in a new system into the loom that has already been spliced into with the old system.

Worzal give simoin a try at lpgc he is good and reasonably priced only does work that is necessary. He is one of these ones that prefers to fix rather than replace.

waddy1200 said:

Worzal give simoin a try at lpgc he is good and reasonably priced only does work that is necessary. He is one of these ones that prefers to fix rather than replace.

Click to expand...

Hi where are they based?

Saint.V8 said:

Back end stuff (Tank etc) can stay aslong as it is in good nick....

Front end can be changed...the only major issue is splicing in a new system into the loom that has already been spliced into with the old system.

Click to expand...

Never thought about that it could be an issue

WURZAL THE LANDY said:

Never thought about that it could be an issue

Click to expand...

Could well be. As ever Saint is ahead of the curve. The electrics in the v8s I have seen have all been a bit brittle.

He is in south elmsall wf92df website is www.lpgc.co.uk

Bit of a trek from up here but thanks

Did it with mine. Got the guys who I'd used before to rip out all the old and replace with new. No problems.

Zorro587 said:

Did it with mine. Got the guys who I'd used before to rip out all the old and replace with new. No problems.

Click to expand...

I take it your old one wasn't working or did you want an upgrade for a newer system. As a rough idea how much less than fitting a full new sysyem I'd you don't mind me asking?

The old one was working but I didn't trust it. The filler nozzle was through the rear bumper on a rigid pipe (that and 2 cable ties were the only thing holding bumper in place!). I got them to remove everything. There was both a cylinder tank and a donut in the spare wheel well. Dumped the donut and got a spare wheel back. Dumped the small cylinder in favour of a larger cylinder to replace both. Don't know how the wiring etc fared, but the switch /gauge was huge and poorly mounted in the dash. I had everything removed and replaced lock, stock and barrel. I think I paid 1k all in, old out and new in. Strangely was 200 less than he charged me to install into my old Cherokee ??