Freelander 1 Low on power - turbo vacuum pipes

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Mr K

Active Member
Posts
176
Location
Bedfordshire
FL1, 2004, TD4.
Recently I have noticed a lack of torque, it struggled with steep hills and slow pulling away, motorway speeds were fine, no smoke or ECU lights.
I had a look around the engine bay for anything obvious, I removed the injector cover so I could check the turbo vacuum pipe,when I touched the pipe the cloth weave started to fall away as it was rotten, I then disconnect the pipe from the vacuum chamber end and sucked on it to check for holes/splits, it held the vaccum so no issues there, I then noticed that the pipe had gone very soft where it routes under the intake pipe and when I sucked on the pipe this area collapsed resulting in limited or no vacuum hitting the turbo solenoid.
I bought 3m of 4mm silicone from ebay for £12 and replaced all the rubber vacuum pipes, whilst doing this the soleniod came away from it's mount so I relocated it.
The new pipes have transformed the performance and it now pulls like a train, I've also noticed the pipe coming out of my Alisport Intercooler is warm whereas before it was cold which shows the turbo is creating a lot more boost.
If you haven't changed your vacuum pipes then for the sake of £12 and 30 mins easy work I recommend you do as they will fail at some point.
 

Attachments

  • IMG_5602.JPG
    IMG_5602.JPG
    178.9 KB · Views: 221
  • IMG_5605(1).JPG
    IMG_5605(1).JPG
    261 KB · Views: 222
  • IMG_5607(1).JPG
    IMG_5607(1).JPG
    272.6 KB · Views: 245
  • IMG_5609 Copy.JPG
    IMG_5609 Copy.JPG
    235.2 KB · Views: 243
  • IMG_5610(1).JPG
    IMG_5610(1).JPG
    203.6 KB · Views: 238
  • IMG_5612(1).JPG
    IMG_5612(1).JPG
    176.9 KB · Views: 228
Last edited:
FL1, 2004, TD4.
I bought 3m of 4mm silicone from ebay for £12 and replaced all the rubber vacuum pipes, whilst doing this the soleniod came away from it's mount so I relocated it.


Is it 4mm interior diameter? And does the pipe need to have any kind of heat resistance?
 
Back
Top