Disco 1 Lost drive to rear wheels
- Thread starter fozt
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 83,230
- Location
- Embasinga stocæ
Magicgrotto
Well-Known Member
- Posts
- 2,769
- Location
- doncaster
Not when i am trying to get him some help
LIGHTEN UP M/H/M !
Just give whoever going to give him a hand those directions & I'm shure they will find him !
biketeacherdave
Well-Known Member
- Posts
- 4,656
- Location
- south east london
Iv got a welder sitting in me garage but I sunk a couple of very large red wines with me dinner
BLASER
Active Member
- Posts
- 140
- Location
- walking distance from craddocks
Cut/drill bolt head off then use socket twist extractor to remove wot is left if you haven't got that bit o kit then I can always get it posted to you if you promise to post it back hope that helps
Thanks Blaser - really appreciate it. But they're out now!
- Posts
- 83,230
- Location
- Embasinga stocæ
why dint ya cut the bolt head off ?
?I did! Wouldn't budgewhy dint ya cut the bolt head off
Took a lot of cutting and hammering to get that last bolt free! It was just super tight in the half shaft bolt hole - as i say, the (remainder of) bolt came out by hand one the shaft was out.
- Posts
- 83,230
- Location
- Embasinga stocæ
I did! Wouldn't budge
first post sounds like yu cut the half shafts
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
Easy enough to check if it is the diff.
Did you try spinning the wheels when they were jacked up?
Cheers
Did you try spinning the wheels when they were jacked up?
Cheers
first post sounds like yu cut the half shafts
haha you're right it does - i didn't literally cut them to pieces! But they're in no good state to reuse, so i'll need to get some more. One of them had slight notching on the splines.
Yes, the wheels did spin whilst it was jacked up
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
Did the opposite side turn at the same time? and did you try turning the prop?
Ahh that makes sense now.
I only had one side jacked up!
Tomorrow I'll see if the rear prop spins when it's in gear - if not then i assume transfer box, if it does then diff?
Foz
- Posts
- 83,230
- Location
- Embasinga stocæ
with one wheel is on the ground and the gearbox in gear (handbrake off), try turning the wheel in the air.
if the wheel turns, but the prop doesnt then its diff.
if the wheel and prop turns its tf box
if the wheel turns, but the prop doesnt then its diff.
if the wheel and prop turns its tf box
I just thought of this exact idea - but now there are no half shafts in the axles
- Posts
- 83,230
- Location
- Embasinga stocæ
slide them back in, and fix with a couple of loose bolts.I just thought of this exact idea - but now there are no half shafts in the axles
Bit dark so i chose the easy option.
I forgot I have a phone with a CAMERA.
Started car, in gear, out of diff lock, handbrake off and the rear prop spun like a goodun - diff it is then!
Thanks for your help, all
bankz5152
Well-Known Member
- Posts
- 9,151
- Location
- South London/North Kent
Sorry just saw this! Had some major family issues past few days. I have got a spare rear diff if you need it back on the road asap?
