looking for help identifying clunk

Dippypud said:

Giggle pin ...

And it's poohed ...

Click to expand...

110tim said:

that is the anti roll bar link, it is a well known failure point easy to replace but use a quality make or genuine

Click to expand...

Dippypud said:

It's a roll link joint that isn't joining in very well ...

A grown-up will be along soon to put me to bed and help you properly ...

Click to expand...

andyfreelandy said:

Never seen one part like that, but they knock on rough road surfaces when worn.
Still think you should check the vcu clunk as above. Looks like the vehicle is lacking in maintenance so check everything!!

Click to expand...

Nodge68 said:

The ball joint should be swaged into the joint.
It's definitely fubar, and it's an MOT failure too, so change it ASAP.
It's called the ARB drop link.

Click to expand...

kernowsvenski said:

You'll find them in the miscellaneous section of Rimmers site, next to stripey paint and sky hooks

Click to expand...

MGT said:

Ok, think I may have found culprit.
To my shame I do not know what this is called. Next to the right wheel. It is intact on the other side, with the boot intact too. When I found it it seemed to be half in half out. I think as I was turning wheel it was disengaging then re-engaging. Hell of a noise for a small component though. Please tell me what it is, and by all means mock me while doing so.View attachment 247256

Click to expand...

Andy Warren said:

Hi, as others have said it's a droplink. I had a set fail in under a 1,000 miles so I got Lemforder ones (or you can get genuine) & they've been trouble free for about 10,000 so far.

Click to expand...

MGT said:

Thanks. Quite relieved to have identified the source. Given the noise I thought it was going to be something fairly major. Still, give it time. I'm getting more used now to things going wrong. I've just done the callipers both sides at the front after both of them seized. One I swapped complete, the other I managed to pop the piston and replace the seals. No sooner had I done that then this clunking kicked in. It will be something else soon.

Click to expand...

Andy Warren said:

It could be worth checking the anti roll bar (ARB) bushes & clamps whilst your there.

Click to expand...