lights...pleaseee

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Joebail

New Member
Posts
7
I have td5 defender 110. I have replaced side light / dipped light switch after fuse burnt out. On the point of fuses....never buy cheap fuses like I did. The plastic casing melted and the two blades joined so no fuse. The fault was traced to the rear tail light. so i got my lights back. But the feed wire to the switch (brown wire) was dead. So a different live wire was found and i got lights back. Lights went again last week so I replaced high beam switch as I felt all along this was faulty. but it didnt work. I think now original fuse problem has caused some wires to burn out somewhere along the way.
Would any one have a wiring diagram where I could replace the wire.
 
Thanks very much going to down load that in a few minutes...bet it is'nt mac compatitable......story of m
 
Thanks very much going to down load that in a few minutes...bet it is'nt mac compatitable......story of m

You can open it with Preview (which you should have as standard). It is a good idea to set Preview as the default for .pdf files as there are loads of them out there.
 
You can open it with Preview (which you should have as standard). It is a good idea to set Preview as the default for .pdf files as there are loads of them out there.

why is opening it with Preview any better than opening .pdf files with the native application ? (adobe reader)
 
but does Preview support indexing and searching and probably lots of other features that the Reader does
 
Back
Top