land rover 2a

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

sid2010

Member
Posts
31
Location
penrith cumbria
pleases help re; bulkhead vent seals.
old ones disintegrated after the old lass stood in an orchard for 2 years , so i gently removed the pins from the vents and removed them and cleaned up the old metal, what would anyone advise me to repaint the bare metal with before i re assemble, and what would be the best contact adhesive to use to re stick new seals with.
 

Attachments

  • IMG_20200912_103534.jpg
    IMG_20200912_103534.jpg
    410 KB · Views: 83
I used superglue but only because that's all I had. Seems to have worked though. I would think any etch primer will be ok for the paint.

Col
 
i've got a tin of red oxide that i was going to use but wanted to check before i went ahead.
more concerned about the glue paint combination as the seals have cost me £16 and i don't want to mess them up.
 

Attachments

  • IMG_20200912_103634.jpg
    IMG_20200912_103634.jpg
    259.5 KB · Views: 89
I haven't had any paint peeling cos of the glue, in fact, it's about the only part of the entire landy that doesn't have paint peeling. Make sure you clean the bit were the seal sticks to, I used petrol.

Col
 
Back
Top