l322 m57 td6
- Thread starter Jedd
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Datatek
Well-Known Member
- Posts
- 45,018
- Location
- Near Poitiers SW France
If it's plastic like the P38 and needs to be replaced, hammer and chisel on the edge.
yes got a new one , just needed some advice before I butcher it. Thanks
Datatek
Well-Known Member
- Posts
- 45,018
- Location
- Near Poitiers SW France
Just go gently.
was wondering if I was to drill the top of cap and put two self tappers in and put a screwdriver across would that help.
brianp38dse
Well-Known Member
- Posts
- 20,093
- Location
- heathrow
On mine I used a very large pair of grips, fortunately I have pairs big enough that I use for work
Datatek
Well-Known Member
- Posts
- 45,018
- Location
- Near Poitiers SW France
Might drop swarf into the housing and I suspect they would just break out.
Swipe
Member
- Posts
- 10
- Location
- West Sussex
Got a pair of these from ecp for the oil filter removal.On mine I used a very large pair of grips, fortunately I have pairs big enough that I use for work
Attachments
Last edited:
shall be getting a pair ready for the next oil change looks like they will do the trick, thanks
freelance
Well-Known Member
- Posts
- 8,702
- Location
- essex and beyond
those would have done the job.
