Breather pipes blocked or leaking or a failed idle valve get the ecu tested
If your driving involves a lot of idling I wouldn't drive it like this, camshaft wear at such low RPM will be significantly accelerated.
Oh god don't say that! It's had a low since i bought it about 9 months ago.
I didn't realise you could wear a metal part down more by making it move slower?
Camshafts lobes - like big end journals - are lubricated by the hydrodynamic wedge principle, the relative movement of the two surfaces forms a wedge of oil which the cam-lobe "surfs" on, when the nose of the camshaft lobe reaches the follower, this wedge starts to break down as it spills off the nose of the lobe, also if the lobe is moving too slowly the wedge isn't properly formed, at low RPM the window of opportunity where the spillage and therefore breakdown of the wedge will increase possibly leading to the nose of the cam being dragged slowly over the follower instead of on a wedge of oil. This is why a slower moving lobe will increase wear. The removal of zinc from modern oil (to protect catalytic converters) doesn't exactly help matters either as this was the last line of defence against metal to metal contact, and there's nothing remotely as good as it to provide the same characteristic.
Depending on clearances and amount of wear, the big-ends may suffer too, oil pressure and flow isn't exactly generous at idle with Rover V8s, at very low rpm oil spillage from the big-ends may outstrip supply, the reduced rotational speed will also inhibit the formation of the hydrodynamic wedge as described above encouraging metal to metal contact.
at the rear of the engine , remove the cabin filter houseing - 2 13mm nuts and slide out the remove the engine cover , then you will have to mount the slam panel and lie on top of the engine put some old coats/jackets on the engine to make it more comfortable , then look at the rear of the inlet manifold you will see 2 large vacuum pipes running to the pcv valve check these as they go all gummy and soft and even flat and holed .if they are they will need to be changed along with the pcv valve and the 2 smaller vacuum hoses , it would be a false economy not to change them allAll the ECU's are fine according to LR.
Where are the breather pipes so i can check them? Cheers guys.
Welcome To LandyZone, the Land Rover Forums!
Here at LandyZone we have plenty of very knowledgable members so if you have any questions about your Land Rover or just want to connect with other Landy owners, you're in the right place.
Registering is free and easy just click here, we hope to see you on the forums soon!