pete12345
Well-Known Member
- Posts
- 2,463
- Location
- Isle Sheppy
Replaced batteries in the fob but now it won't work it all lights up but won't unlock or start car is it a new one needed or could rick do a job on it
Key fob woes
- Thread starter pete12345
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
biketeacherdave
Well-Known Member
- Posts
- 4,982
- Location
- south east london
You need to sync it mate
- Posts
- 58,170
- Location
- Preston Lancs.
You have a max of ten minutes maybe less to change the batteries before the fob forgets it is synced. You will need to enter EKA code then sync it to the car. If the car is 1997 or on just putting it in the ignition should do that.
Grrrrrr
Technician, Bodgit & Scarper Ltd
- Posts
- 19,910
- Location
- Buckinghamshire, UK. ('95 DT)
Battery in the right way up? 
pete12345
Well-Known Member
- Posts
- 2,463
- Location
- Isle Sheppy
Yer batteries up right way coz it's lights up it b eka code by sounds ov it cheers will give that a try
danb79
Member
- Posts
- 84
- Location
- devizes wiltshire uk
pete12345
Well-Known Member
- Posts
- 2,463
- Location
- Isle Sheppy
Thanks for help had to plug in nanocom and rewrite settings all seemed good after that had no joy putting key in ignition and holding button down but seems ok now
pete12345
Well-Known Member
- Posts
- 2,463
- Location
- Isle Sheppy
2nd new problem today number 2 key fob put new back on it re synced it with nanocom as did with last key but it won't unlock the doors but starts vehicle ok any ideas much appreciated
Grrrrrr
Technician, Bodgit & Scarper Ltd
- Posts
- 19,910
- Location
- Buckinghamshire, UK. ('95 DT)
Is the RF receiver under the rear parcel shelf (RHS) plugged in?
Pretty certain when I synched mine I just pressed the unlock button then unlocked with the key. Or maybe it was lock. Then just put the key in the ignition and it started. Took a few attempts, I remember that.
Pretty certain when I synched mine I just pressed the unlock button then unlocked with the key. Or maybe it was lock. Then just put the key in the ignition and it started. Took a few attempts, I remember that.
pete12345
Well-Known Member
- Posts
- 2,463
- Location
- Isle Sheppy
Yer tried that with both keys no luck with either but no1 key ok now after reading codes with nanocom key no2 starts engine just won't unlock doors
